Although there’s never been any question that there’s something going on with the iPhone 4′s fancy new antenna system, we really haven’t seen any rigorous testing confirming that the issue is real, severe, and affects every phone. That just changed: Consumer Reports tested three iPhone 4s and several other AT&T phones in their RF isolation chamber that simulates varying levels of signal from every carrier, and found that the iPhone 4 was the only handset to suffer signal-loss issues. What’s more, CR directly says that its findings call Apple’s explanation of a miscalculated signal meter into question since the tests “indicate that AT&T’s network might not be the primary suspect.” CR found that simply putting duct tape over the bottom-left corner is enough to alleviate the issue — we’re guessing that’s Jony Ive’s worst nightmare — and says that while the iPhone 4 has the “sharpest display and best video camera” of any phone it’s tested, it simply can’t recommend the device until Apple comes up with a permanent and free fix to the antenna problem. Ouch.

Of course, we couldn’t sit around waiting for someone else to test the iPhone 4 in a more controlled way, so we actually asked our good friend Erica Sadun from TUAW to write us a bespoke signal strength app for iOS 4. Obviously we couldn’t submit it to the App Store, but we’ve been running it on all of our phones here at Engadget and we can independently confirm Consumer Reports‘ finding that there’s a serious signal attenuation issue with the iPhone 4′s antenna — every phone we’ve tested displays dropped signal when held with the bottom left corner covered. Now, what we don’t know is whether that signal attenuation consistently affects call quality and data rates, which we suspect is more directly related to the network in the area; some of our iPhone 4s drop calls and experience low data rates with alarming frequency, while others — like our review unit — have almost never dropped a call and have had no data problems. However, now that we’ve confirmed and clarified that the antenna issue affects every iPhone 4, we can take on the next step, which is sorting out exactly when and where the issue is most severe. Either that, or Apple can do something to actually fix the issue — we’ll just have to wait and see. For now, check our app in action after the break.

Update: To clarify, “here at Engadget” is a virtual location — our iPhone 4s are actually located across the country in San Francisco, Chicago, and New York, and we saw the app respond that way regardless of location. Dropped calls and other effects weren’t as consistent, however, and we’re still testing to sort out when the effects of the antenna issue are the most severe.

Continue reading Consumer Reports confirms iPhone 4 antenna problems — and so do we

Consumer Reports confirms iPhone 4 antenna problems — and so do we originally appeared on Engadget on Mon, 12 Jul 2010 13:30:00 EST. Please see our terms for use of feeds.

Permalink | Email this | Comments

The iPhone 4‘s antenna issues have sparked off a firestorm of debate as to the root cause — Apple says holding the phone differently or buying a case are the best answers, while other are going down a more voodoo path — but our friends at AnandTech have done some more scientific testing of the problem and come up with a few interesting results. Turns out the iPhone 4 actually performs slightly better inside a case than a phone like the Nexus One, which has had similar issues crop up, but it’s slightly worse when held in the hand, reporting an average signal drop of 20dB. Here’s where it gets a little wacky, though: the signal meter in iOS 4 is logarithmic, so that 20dB drop can either leave you looking steady at five bars or drop you all the way to zero, depending on what the actual signal level in the area is like. Take a look at the chart above and you’ll get it: the range of values between one bar and four spans just 23dB, while the range for five bars is 40dB. That means holding the phone in an area with a strong five-bar signal will have no apparent effect — you can lose 20dB at full signal and still see five bars — but holding the phone in an area with weaker coverage will easily drop the meter to one bar, since the 20dB signal drop covers almost the entirety of the remaining 23dB scale. Oops.

Of course, that’s just the on-screen display, which Apple can and likely will tweak in a future iOS update. The real question is whether the reported signal has anything to do with performance, and Anandtech agrees with our general experience, saying that the iPhone 4′s improved signal to noise ratio means it actually does a better job of hanging onto calls and using data when there’s low signal than the iPhone 3GS. In their words, “this iPhone gets the best cellular reception yet, even though measured signal is lower than the 3GS.” However, there’s no getting around the fact that we’ve definitely dropped a couple calls with the iPhone 4 by holding it the wrong way, and Anandtech says the only real solution to the antenna issue will be for Apple to either subsidize free bumpers or add an insulative coating to the antenna band. We’ll see what happens — we’ve got a feeling an iOS update is on the way, but we’d definitely love to see Apple pursue a more aggressive solution to this problem.

iPhone 4′s antenna problem looks worse than it is, but it’s still bad originally appeared on Engadget on Wed, 30 Jun 2010 14:26:00 EST. Please see our terms for use of feeds.

Permalink | Email this | Comments